Learn F5 Technologies, Get Answers & Share Community Solutions Join DevCentral

Filter by:
  • Solution
  • Technology
Clear all filters
Answers

BIG-IQ - Replacing bigip.conf file from old UCS

When I originally set up an initial BIG-IQ on some 7000 hardware chassis, it took me a long time to finally get the LDAP settings correct.

We've since removed those chassis and I'm working in a VE for BIG-IQ. I'm following the steps here to extract specific files from a UCS.

I'd like to restore the User Management > Auth Providers entirely, but cp /var/tmp/old/config/bigip/auth/* /config/bigip/auth/ doesn't appear to be working.

Is there a better way to do this? Restoring from UCS but editing the management IP address? I'm open to ideas.

0
Rate this Question
Comments on this Question
Comment made 2 months ago by Zuke 348

I've copied the extracted /config/bigip.conf file to /config/bigip.conf2 , renamed it to /config/bigip.conf and then tmsh /save/sys config partitions all

After the config saves, the bigip.conf file reverts to the previous default configuration.

0

Answers to this Question

placeholder+image
USER ACCEPTED ANSWER & F5 ACCEPTED ANSWER

If you are editing the config files directly, you will need to use the 'tmsh load sys config' command. The config files on the F5 devices are considered the startup configuration files and so every time you save the system configuration, you are overwriting the startup config with whatever the currently running config is. Be careful with editing config files directly and ensure you make plenty of backups.

Hope this helps.

0