Forum Discussion

Phu_Nguyen_7215's avatar
Phu_Nguyen_7215
Icon for Nimbostratus rankNimbostratus
Nov 07, 2011

Pool members disconnected after adding new float IP

I'm configuring a new a new interface for a LTM Big IP 3900, when i configured a new float IP address, this caused two nodes from the other pool of this LTM disconnected. Is this a known bug of the LTM ? Thanks.
config
design

3 Replies

Sort By
  • nitass's avatar
    nitass
    Icon for Employee rankEmployee
    Nov 07, 2011
    this caused two nodes from the other pool of this LTM disconnected.what does this mean? does health monitor fail? is client unable to connect to pool through virtual server?

     

     

    by the way, does bigip have floating selfip on every VLAN?
  • Phu_Nguyen_7215's avatar
    Phu_Nguyen_7215
    Icon for Nimbostratus rankNimbostratus
    Nov 07, 2011
    yes, the two nodes on different VLAN failed health check. The existing VLANs don't have floating IP configured. Thanks.
  • nitass's avatar
    nitass
    Icon for Employee rankEmployee
    Nov 08, 2011
    yes, the two nodes on different VLAN failed health check. The existing VLANs don't have floating IP configured. health monitor should use non-floating selfip as source address, so it should not be affected when adding a new floating selfip.

     

     

    to troubleshoot health monitor issue, this article may be helpful.

     

     

    Troubleshooting Ltm Monitors by Aaron

     

    http://devcentral.f5.com/wiki/AdvDesignConfig.TroubleshootingLtmMonitors.ashx