Forum Discussion

nanukanu_263047's avatar
nanukanu_263047
Icon for Nimbostratus rankNimbostratus
May 23, 2016
Solved

Failover just with HA interface

Hi,

 

Actually playing with HA environment with 2 LTM, when configuring Failover, by default HA & Management address are selected and it Works correctly (active / passive), but when I put only HA (without management in unicast failover section) both F5 shows state ACTIVE / ACTIVE and each one appears to other as Offline.

 

It's necessary always include MGMT address? I'm conecting directly the 2 nodes without passing through a Switch, that's correct? or it's imperative interconect through switch?

 

Many thanks!!

 

application delivery
LTM
  • Hannes_Rapp_162's avatar
    Hannes_Rapp_162
    May 24, 2016

    Active/Active status is probably caused by Port lockdown 'None' configuration on your HA VLAN/SelfIP which is the default setting. Set it to 'default', and try again. Specifying the management interface in network failover configuration is not necessary at all.

     

4 Replies

Sort By
  • Hannes_Rapp_162's avatar
    Hannes_Rapp_162
    Icon for Nacreous rankNacreous
    May 24, 2016

    Active/Active status is probably caused by Port lockdown 'None' configuration on your HA VLAN/SelfIP which is the default setting. Set it to 'default', and try again. Specifying the management interface in network failover configuration is not necessary at all.

     

  • Hannes_Rapp's avatar
    Hannes_Rapp
    Icon for Nimbostratus rankNimbostratus
    May 24, 2016

    Active/Active status is probably caused by Port lockdown 'None' configuration on your HA VLAN/SelfIP which is the default setting. Set it to 'default', and try again. Specifying the management interface in network failover configuration is not necessary at all.