Forum Discussion
Dec 10, 2018
Hey Anthony
Can you perform a configuration sync?
Have you checked so that the BIG-IP devices are listening over the correct failover unicast address/port? Run the following command on both devices:
netstat -na | grep 1026
The output should look like this:
[root@bigip02:Active:Changes Pending] log netstat -na | grep 1026
udp 0 0 192.168.1.32:1026 0.0.0.0:*
udp 0 0 10.10.10.32:1026 0.0.0.0:*
This setting is configured per device under: Device Management ›› Devices ›› [BIG-IP Hostname] ›› Failover Network.
I think that if it's missing it could present the scenario you have.
I hope this helps! 🙂