Doubt about "min-up-member" when LB is ratio-member

Hi Victor,

the

min-active-members

(Priority Based Activation Configuration) and the

min-up-members

(Failsafe configuration) settings are completely distinct from each other. You may read TMSH's command syntax help for further information and or read the online manuals for Priority Based Activation Configuration and Failsafe configurations

[user@hostname:Active:Standalone] ~  tmsh modify /ltm pool * ?

min-active-members

Specifies the minimum number of members that must be up for traffic to be confined to a priority group when using priority-based activation. The default value is 0 (zero). An active member is a member that is up (not marked down) and is handling fewer connections than its connection limit.

min-up-members

Specifies the minimum number of pool members that must be up; otherwise, the system takes the action specified in the min-up-members-action option. Use this option for gateway pools in a redundant system where a unit number is applied to a pool. This indicates that the pool is only configured on the specified unit.

min-up-members-action

Specifies the action to take if the min-up-members-checking is enabled and the number of active pool members falls below the number specified in min-up-members. The default value is failover.

min-up-members-checking

Enables or disables the min-up-members feature. If you enable this feature, you must also specify a value for both the min-up-members and min-up-members-action options.

Cheers, Kai