Forum Discussion
Philippe_Page_2
Oct 17, 2016Cirrus
From our end (10.4.4.101) we can ping the F5 Big IP gateway, also the management IP of the Juniper device and the other end device. However, I'm not sure if im pinging the correct device since when I check the IPsec Diagnostic on F5, it shows that the tunnel selector is Down.
I also had the experience to establish IPsec between 2 F5 Big IP equipments connecting two end points using inter VLAN on 2 different data center, but I still have little knowledge as to how to troubleshoot this certain scenarios since it's new to me. I just copied the working IPsec (IPsec between 2 F5 equipments) and applied it to this situation. Thank your for responding.