Posted By nitass on 10/23/2012 06:59 AM
I'm using the HA Self IP's and VLAN's for that and HA VLAN is associated with 1.4 on both Untagged.
that is fine. you may run "tail -f /var/log/ltm" on both units while performing configsync to see if there is any error log.
and just in case if you have not yet seen this sol.
sol13887: Forcing a BIG-IP device group member to initiate a ConfigSync operation
http://support.f5.com/kb/en-us/solutions/public/13000/800/sol13887.html
Thank you again, I setup the device as the config leader and also tried to do a forced sync from the GUI no use. I seem to not have the tail command available to me. I logged in as the local admin and still same results. Do I need to create an internal VLAN for this per the link below device uses internal VLAN.
https://support.f5.com/kb/en-us/products/big-ip_ltm/manuals/product/tmos-redundant-systems-config-11-2-0/2.htmlconceptid
Also when I remove the Management IP from the "System --> High Availability --> Device connectivity --> Failover" and just leave the HA VLAN in there that is associated with 1.4 port (1.4 to 1.4) my failover stops working too.