Forum Discussion

navgup_66025's avatar
navgup_66025
Icon for Nimbostratus rankNimbostratus
Mar 17, 2009

Redundant LTM3600 pair on different subnets

Currently, I am using LTM 3600 in a redundant pair (active/standby mode) inside the company's network. No traffic is coming from outside. Both units are configured under the same subnet1.

 

 

Can i configure unit1 under subnet1 and unit2 under subnet2 while keeping them as redundant in a pair and Active/standby mode?

 

My worry is,

 

- how would the internal floating (shared) address be defined?

 

 

config
design

13 Replies

Sort By
Show More
  • The_Bhattman's avatar
    The_Bhattman
    Icon for Nimbostratus rankNimbostratus
    Apr 13, 2009
    I believe a combination of GRE and pseudo wire technique (L2 Tunnelig protocol see: Click here)

     

     

    This is assuming that you using Cisco as end-to-end termination points.

     

     

    CB

     

  • The_Bhattman's avatar
    The_Bhattman
    Icon for Nimbostratus rankNimbostratus
    Apr 13, 2009
    Here you go "http://www.cisco.com/en/US/tech/tk364/technologies_configuration_example09186a00801f66fa.shtml"

     

     

    CB