Forum Discussion

Senthil_7991's avatar
Senthil_7991
Icon for Nimbostratus rankNimbostratus
Feb 17, 2018

Software Upgrade Plan Question - Relate with cpcfg command

We planning to upgrade our LTM from version 11.6.1 HF1 to 11.6.2 HF1 , we going to follow this below procedure, Do we really need "cpcfg --source=HD1.2 HD1.3" before the upgrade?.   Because the r...
application delivery
LTM
senthil147_1421's avatar
senthil147_1421
Icon for Nimbostratus rankNimbostratus

Yes cpcfg is needed to copy the configurations to newly created disk volume from old active volume. Execute the command after installing the new image.

 

License activation will be first step . So cpcfg needs to be done after installing the new image. Thanks, Senthil

 

JoshBecigneul's avatar
JoshBecigneul
Icon for MVP rankMVP
Feb 17, 2018

I wouldn't run that command if you've already switched into the target volume. I believe it is only required if you run the installation for the new software without rebooting into it immediately, and then make changes that you later need to carry forward into the new installation slot. If you use the cli option 

reboot
in the 
install
command, it should carry the configuration over.

Also, if you reboot via the WebUI, and select Yes for "Install Configuration" and specify the source/destination appropriately, it should carry over your config.