Forum Discussion
12 Replies
Sort By
- kridsanaCirrocumulus
Updated
Now I using step install
- upgrade From 9.1.2 HD1.2 >> PXE install 9.3.1 in HD1.2>> image2disk 10.2.4 in HD1.1 (partition) >> install 9.1.2 another partition via PXE (this last step is crashed and everything is empty , box clean)
- kridsanaCirrocumulus
Updated again.
I tried install 9.1.2 & 10.2.4 .. it can install in same box but it occur
- Error 24: Attempt to access block outside partition
- Error 18: Selected cylinder exceeds maximum supported by BIOS
so forget about 9.1.2 & 10.2.4. I just update into 10.2.4 standalone in Volume (this is easier -_-) and everything work fine except alert.conf and postfix didn't roll forward into new firmware?