Forum Discussion

Eddie_Daki_3416's avatar
Eddie_Daki_3416
Icon for Nimbostratus rankNimbostratus
Nov 21, 2017

How to manually set time in LTM

I was in the process of adding one of my LTM appliances to Big-IQ and it failed with an error message that read " Discovery of device XX.XXX.XX.XXX failed because the difference in time between this BIG-IQ and the BIG-IQ is greater than 300 seconds." I'm using the same NTP servers for both the appliance and Big-IQ. Now I simply want to know how to manually adjust the time on the LTM appliance.

 

application delivery
BIG-IQ
LTM

1 Reply

Sort By
  • Chase_Abbott's avatar
    Chase_Abbott
    Icon for Employee rankEmployee
    Nov 21, 2017

    Support KB3381 will apply for this issue.

    1. Log in to the command line.
    2. To change the operating system time, use the following command syntax: 
      date .

    The specific format is as follows:

    date MMDDHHMMYYYY.SS

    For example, to set the time to 1:00pm on January 1, 2007, you would type the following command:

    date 010113002007.00

    1. To save the time to the hardware clock (BIOS), type the following command: 
      hwclock --systohc
    2. To ensure that the BIG-IP system daemons operate and log properly once the operating system clock has been changed, you will need to reboot the BIG-IP system. To reboot the BIG-IP system, type the following command: reboot
    3. After the system has rebooted, you can verify the system time and the hardware clock time by typing the following command at the BIG-IP command line: 
      date ; hwclock

    The output appears similar to the following example: 

    Thu Oct 22 17:03:16 PDT 2009
    Thu Oct 22 17:03:16 2009 -0.000328 seconds