Multi interface VLAN and VLAN Failsafe
Hi, I was not able to find definitive answer in docs and I have problem to do real life test, so maybe someone used described configuration and did testing - will appreciate info how such setup behave. Configuration Active-Standby cluster VLAN A with interface 1.3, 1.4, 1.5 assigned VLAN Failsafe set on VLAN A with Failover as action Three servers each containing 2 NIC IPs used by servers defined as Nodes and used by Pool assigned to VS Interface 1.3 connected directly to NIC1 on Server A, 1.4 to NIC1 on Server B etc. Same connection on Standby unit using NIC2 on servers (HA between NIC on servers somehow managed by servers itself, have no info how it is configured but at given time IP assigned to server is always linked to MAC of only one NIC) I wonder how failsafe will behave assuming scenario below Let's say that Server A crashed or was power off Considering above there is not network traffic on BIG-IP interface 1.3 Servers 2 and 3 are working OK, so there is traffic on interfaces 1.4, 1.5 Considering that failsafe is set on VLAN level not on interface level (and VLAN has three interfaces assigned, not trunk configured, just separate interfaces) will lack of network on one interface (1.3) will cause failover to Standby - even if traffic is detected on remaining two interfaces assigned to VLAN A? Or detecting traffic on at least one interface assigned to VLAN A will prevent failover? Piotr
vlan failsafe don`t work on vcmp guest
Hello, I have a 2x5250V (VCMP). I have installed three guests (Prod,dmz and QA) on both of them host. These Guests are connected on the same Vlans for HA & the following vlan for each guest: prod1/prod2 guest are in failover active/standby, external vlan2, internal vlan12, ha vlan30 dmz1/dmz2 guest are in failover active/standby, external vlan3, internal vlan13, ha vlan30 qa1/qa2 guest are in failover active/standby, external vlan2, internal vlan12, ha vlan30 When I shutdown the physical port-channel for the vlan 2 and 3 on the switch, the Guests Prod1 and Dmz1 successfully commute with vlan failsafe but guest qa not switch. The active traffic groups located to qa don't switch to standby status and the application does not work properly. on guest qa only work gateway failsafe. How can I do to work vlan failsafe to switch to the neighbord (qa1-->qa2)? Thank you